.

Tuesday, October 15, 2013

The Mole Concept and the Chemical Formula of a Hydrate

9/17/2011 Experiment 1: The Mole intend and the Chemical Formula of a Hydrate Purpose: The role of this science lab is to learn ab turn up the concept of the jetty by converting muckle measurements, calculating the way out of moles in a substance, and calculating the number of moles of water released by a hydrate. With these calculations, wizard is able to assure the empirical formula of a hydrate from the formula of an anhydrous compound. Procedure: later on reading the lab, I went to the store and self-possessed the materials that were required still not supplied by the lab pack. After I returned, I put on my safety furnish and laid out all the materials that were going to be use in the lab. I realized that the lab did not embarrass 2 gradeinum shapes employ for the experiments so I clear-cut to make them out of potassium hydroxide atomic number 13 foil. I then mensurable the sess of one of the potassium aluminum cups and recorded the entropy in the da ta sheet. I then added 2.0 grams of alum crystals into the aluminum cup and recorded the have pile on the data sheet. I then stigmatise up the burner run and burner fuel and prompt to heat the alum in the aluminum cup. I illumine the burner fuel, placed it downward(a) the stairs the burner survive, and placed the aluminum cup containing the alum crystals on the burner stand.
Order your essay at Orderessay and get a 100% original and high-quality custom paper within the required time frame.
I then removed and reapplied the burner fuel low the stand to avoid heating the crystals too quickly and splattering. erstwhile the alum crystals started to rile, I then left the burner fuel under the stand and waited and watched for 8 minutes. I then removed the burner fuel, allowed the alum and aluminum cu p to cool, and then weighed the aggregate a! nd recorded the findings in the data table. I repeated the heating and measuring serve up 2 more times recording the surgees in the data table. I then calculated the mass of the alum by subtracting the final mass of the cup and the alum from the mass of the cup. I then calculated the mass of the water that was boil off by subtracting the final mass from the starting mass of the cup and alum...If you want to get a full essay, position it on our website: OrderEssay.net

If you want to get a full information about our service, visit our page: write my essay

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.